Sleeve Block, McCunn System: Difference between revisions

The '''Wrist Line''' is drawn at a right angle to the Sleeve Centerline with half of the length of the Valentina measurement '''hand_palm_circ''' extending on each side from the center. This line is drawn at the wrist end of the Sleeve Centerline. By using the palm circumference instead of the wrist circumference, we will ensure that the sleeve opening is large enough for the wearer's hand to pass through. <br> <br> The '''shoulder_to_elbow''' Measurement would be used to place the elbow dart to shape the sleeve. Although the book describes adding a dart at the elbow, we will omit that from this tutorial because it does not add to the user's ability to learn to use the Valentina tools.<br> <br>

'''Figure 1-V''' shows the same drawing as '''Figure 1''', but shows the image as it will be presented in the valentina program after you have finished the first half of the detailed steps of this tutorial. These steps of the [[Formulas_McCunn_Sleeve|detailed instructions]] will create this construct which will act as the basis for the arm portion of the sleeve pattern.

The lines shown in the goldenrod color will not be printed on the final pattern. The lines shown in the black color will be incorporated during the '''details''' steps to form part of the printed pattern.

<br> <br>

'''Figure 2''' shows the special points used in constructing the sleeve cap portion of the sleeve.

<br> <br>